Repaired section of inner stress panel

Aluminum paint applied to first section of inner stress panels

Work continues on spraying the chassis

Parts of the pipe work cleaned up with sand blaster and painted

Repair section cleaned up and red oxide applied

Damaged section of aluminum removed for repair

Another damaged section removed this area will be cleaned with the blaster

Spraying red oxide primr

Andy applying filler primer paint

Andy cleaning up a section thats been straightened

Front cross member cleaned up again with sandblater

My new compressor and sandblaster

The GRP wheel arches have been sanded down and grey gelcoat applied

Front wheel hub and drum redone

Good thing with the spray gun it gets in all nooks and crany's

Andy armed with the spray gun

We've had to sand blast work we've already done as the damp in the hanger has caused a bit of surface rust, we are using epoxy 2 pack paint on the chassis now this stuff is used in the north sea so should be good.

Front brake drum getting sand blasted

Up she goes

With bus in the air we can get better access to the chassis again, we'll get the new sand blaster working finish priming the front of the chassis then get some silvering done, the last few months have been so damp w've not got any work done at all. Roll on dry weather!

new 20 ton axle stands and air jack

Paint stripping in progress grp panel will be sent off to be rebuilt

Front GRP panel being stripped of paint